Rockwell Automation RELIANCE ELECTRIC SP500 - 7.6 Drive Control

7.5.1
7.5.2
7.6
A sample monitor mode display is shown in figure 7.4.
[| %Load L_] Program
MH volts LI Forward
Ll] Remote [1 Reverse
STOP
START RESET
( ~
7s.
In ||~ ~
Lt
Mode Forward
L_] RPM L_] RUN Enter Reverse
Figure 7.4 — Example of a Monitor Mode Display
Displaying the Percent Selected Speed Reference
To display the percent selected speed reference, parameter F-13 must be set to ON.
Use the following procedure to display the percent selected speed reference:
Step 1. Stop the drive (if it is running) by pressing the STOP/RESET key.
Step 2. Enter program mode by pressing the MODE/ENTER key until the PROGRAM
LED turns on.
Step 3. Press the ,@ or ‘yw key until F-13 is displayed.
Step 4. Press the MODE/ENTER key to access the parameter.
Step 5. Press the ~@» key until ON is displayed.
Step 6. Press the MODE/ENTER key to save the value. (F-13 will be displayed.)
Step 7. Press the STOP/REST key to exit program mode.
Step 8. Start the drive by pressing the START key.
Step 9. Press the MODE/ENTER key uniil all three monitor mode LEDs are on.
The display will show the active speed reference as 1 to 100% of maximum speed
(F-04).
Scaling the RPM Display and Reference Using F-08
The RPM display and reference can be scaled to an engineering unit to match your
application. Refer to the F-08 description in chapter 8 for this procedure.
Drive Control
When the control source is the local keypad (F-00 = 0), the keypad is used to control
the drive. This means that the drive will respond to START, STOP/RESET, and
FORWARD/REVERSE commands only from the keypad.
7-6 SP500 AC Drive Installation and Operation Manual Version 3.1