Rockwell Automation RELIANCE ELECTRIC SP500 - 7.4 Program Mode

7.4 Program Mode
Program mode allows you to display and modify drive parameter values when the
drive is stopped.
The following can be displayed in program mode:
¢ Parameter numbers
¢ Parameter values
* Error log information
To enter program mode:
Step 1. Stop the drive (if it is running) by pressing the STOP/RESET key.
Step 2. Press the MODE/ENTER key until the PROGRAM LED turns on.
Parameter F-00 will be displayed. Use the ,@» key or ~w key to scroll through the
parameter list. The error log follows parameter F-49 and precedes parameter F-00 as
shown in figure 7.2.
F-00
F-01
F-02
F-49
Err
Jt
Figure 7.2 — SP500 Menu Structure
To exit program mode:
Step 1. Press the MODE/ENTER key until a parameter number or ERR is displayed.
Step 2. Press the STOP/RESET key until the PROGRAM LED turns off.
Important: Pressing the STOP/RESET key while you are examining the error log
clears the log.
7-4 SP500 AC Drive Installation and Operation Manual Version 3.1