Rockwell Automation RELIANCE ELECTRIC SP500 - Page 31

Table 3.7 — Motor Lead Lengths
SP500 HP Maximum Lead Maximum Lead Maximum Lead
Ratin Filter Type Length in Feet with Length in Feet with Length in Feet with
g 230 VAC Motor 460 VAC Motor 575 VAC Motor
Carrier Frequency Carrier Frequency Carrier Frequency
4 kHz 6 kHz 8 kHz 4 kHz 6 kHz 8 kHz 4 kHz 6 kHz 8 kHz
1 500 500 500 250 250 250 150 150 150
2 500 500 500 350 350 350 250 200 200
3 N 1000 1000 1000 400 400 400 250 200 200
one
5 1000 1000 1000 500 500 500 250 200 200
7.5 to 10 N/A N/A N/A 500 500 500 250 250 250
15 to 20 N/A N/A N/A 500 500 500 N/A N/A N/A
1 a, 500 500 500 500 500 500
A reactor/filter is not
2 required. Above lead 500 500 500 500 500 500
3 A 5% MTE lengths are maximum 1000 1000 1000 1000 1000 1000
reactor/filter at the distances.
5 drive. 1000 1000 1000 1000 1000 1000
7.5 to 10 N/A N/A N/A 1000 1000 1000 1000 1000 1000
15 to 20 N/A N/A N/A 1000 1000 1000 N/A N/A N/A
1. Note that the lead lengths listed are valid with Reliance Electric inverter duty motors.
2. N/A indicates that the drive does not have this rating or it is not applicable.
Table 3.8 — Reactors
230 Volt 480 Volt 600 Volt
SP500 HP Rating 5% MTE Reactor 5% MTE Reactor 5% MTE Reactor
1 RL-00402 RL-00202 RL-00203
2 RL-00403 RL-00404
3 RL-00403 RL-00404
5 RL-00803 RL-00804
7.5 RL-01203 RL-00803
10 RL-01803 RL-01203
15 RL-02503
20 RL-03503
1. MTE standard reactors can be used on SP500 drives with carrier frequency settings up to 8 kHz.
2. All reactors listed are UL-recognized (UL-506 File #E53094) and CSA certified (CSA File #LR29753).
SP500 System Planning 3-7