Rockwell Automation RELIANCE ELECTRIC SP500 - 5.4 Grounding

5.4 Grounding
ATTENTION: The user is responsible for conforming with all applicable
local, national, and international codes.
Use the following steps to ground the drive:
Step 1. Remove the drive’s cover.
Step 2. Runa suitable equipment grounding conductor unbroken from the drive’s
ground terminal to the motor’s ground terminal and then to earth ground. See
figures 4.1 through 4.4 and 5.1.
Step 3. Connect a suitable grounding connector to the motor frame and transformer
(if used). Run each conductor unbroken to earth ground.
When adding more than one grounding conductor wire to a single chassis
ground, twist the conductors together.
Step 4. Reattach the drive’s cover.
Wiring the Drive 5-11