Rockwell Automation RELIANCE ELECTRIC SP500 - 7.2 Key Descriptions

7.2 Key Descriptions
The keypad’s six membrane keys are used to monitor, program, and control the drive.
Table 7.1 describes the keys.
Table 7.1 — Key Descriptions
Use the UP and DOWN arrow keys to:
* Step through the drive parameters and error log when the drive is in program mode.
* Increase or decrease a parameter’s numeric value or status in program mode.
* Increase or decrease the internal speed reference when F-00 (Control Source Select) =
0 or 2.
Hold down these keys to increase the scroll speed.
Use the MODE/ENTER key to:
Mode * Advance through each monitor display item in monitor mode.
Enter * Select program mode when the drive is stopped.
* Display a parameter value in program mode.
* Save a parameter value in program mode.
The MODE/ENTER key provides these functions regardless of the control source selected
(local or remote).
Use the FORWARD/REVERSE key to select the direction of motor shaft rotation when the
control source is local (F-00 = 0).
Forward
Reverse
Use the START key to apply power to the motor when the control source is local (F-00 = 0).
When this key is pressed, and there are no active faults, the drive will accelerate to the last
START programmed frequency setpoint (speed).
Use the STOP/RESET key to:
STOP ¢ Turn off the drive output to the motor if the drive is running.
RESET * Clear drive faults when the drive is in program mode.
* Exit program mode.
When this key is pressed, the drive will ramp to rest at a user-defined rate (user option) or
coast to rest (default). This key stops the drive regardless of the selected control source
(remote or local).
7-2 SP500 AC Drive Installation and Operation Manual Version 3.1