Rockwell Automation RELIANCE ELECTRIC SP500 - Page 92

Use the following procedure to access the error log:
Step 1. Enter program mode by pressing the MODE/ENTER key until the
PROGRAM LED turns on.
F-00) 2 ©
(i | (aoe
CI RPM [1 RUN (i | (aoe
[1 %Load lll Program
[5 Volts [5 Forward START STOP
[5 Remote [_] Reverse RESET
Step 2. Press the “W key until ERR is displayed. The error log precedes
parameter F-00 and follows F-49.
[Err SS
Forward
[ RPM [1 RUN (es | Reverse
[1 %Load lll Program
C5 Volts [3 Forward STOP
[5 Remote [_] Reverse START RESET
(Sample Display)
Step 3. Press the MODE/ENTER key to access the error log.
[e-ouJ
(| (ez
Co RPM [) RUN (| (ez
[1 %Load lll Program
C5 Volts [3 Forward START STOP
[5 Remote [_] Reverse RESET
(Sample Display)
Step 4. Press the g, key to move through the error codes.
roo = =
(| Forward
[ RPM [1 RUN (| Reverse
[1 %Load lll Program
C5 Volts [3 Forward START STOP
[5 Remote [_] Reverse RESET
(Sample Display)
9-6 SP500 AC Drive Installation and Operation Manual Version 3.1