Rockwell Automation Reliance electric SP600 Series - List of Tables

Contents IX
List of Tables
Table 2.1 – Identifying the NEMA 1 Drive by Frame...................................2-3
Table 2.2 – Identifying the NEMA 4x/12 Drive by Frame............................2-3
Table 2.3 – 208/240 VAC Power Ratings...................................................2-4
Table 2.4 – 400/480 VAC Power Ratings...................................................2-5
Table 2.5 – 600 VAC Power Ratings ..........................................................2-6
Table 2.6 – SP600 Drives EN1800-3 (Second Environment)
Compatibility ........................................................................2-20
Table 2.7 – Communication Options Model Numbers and
Instruction Manual Numbers...............................................2-23
Table 2.8 – Remote OIM Model Numbers and Instruction
Manual Numbers..................................................................2-23
Table 2.9 – PC-Based Utility Model Number and Instruction
Manual Number ...................................................................2-24
Table 3.1 – MOV and Common Mode Capacitor Jumpers.........................3-4
Table 3.2 – SP600 Frames.........................................................................3-7
Table 4.1 – Recommended Shielded Wire .................................................4-3
Table 4.2 – Power Terminal Block Specifications.......................................4-3
Table 4.3 – Recommended Signal and Control Wire..................................4-5
Table 4.4 – I/O Terminal Block Specifications ............................................4-5
Table 4.5 – SP600 208/240 VAC Input Recommended
Protection Devices...............................................................4-10
Table 4.6 – SP600 400/480 VAC Input Recommended
Protection Devices...............................................................4-11
Table 4.7 – SP600 600 VAC Input Recommended Protection Devices ...4-12
Table 6.1 – Terminal Tightening Torques...................................................6-5
Table 6.2 – AC Line Reactors.....................................................................6-6
Table 6.3 – Braking Resistor Capacity......................................................6-11
Table 7.1 – Wiring Signal and Control I/O to the Terminal Block................7-3
Table 7.2 – I/O Wiring Examples ................................................................7-5
Table 7.3 – Parameter Configuration for Figure 7.1 Wiring Example .........7-8
Table 9.1 – Key Functions ..........................................................................9-4
Table 9.2 – How to Adjust Each Parameter Type.......................................9-8
Table 10.1 – Quickstart Parameters .........................................................10-3
Table 12.1 – Parameter List......................................................................12-2
Table 12.2 – Default Values for Preset Speeds 1-7................................12-26
Table 12.3 – Dynamic User Set Mode....................................................12-60
Table 12.4 – Analog Output Scaling.......................................................12-86