About the Drive
2-21
2.6 Drive Connections
Figure 2.4 shows the locations of the drive terminal blocks and
connectors used to set up and operate the drive on NEMA 1 drives.
No. Connector Description
DPI Port 1 OIM connection when installed in cover.
DPI Port 2 Cable connection for remote OIM or
VS Utilities.
DPI Port 3 Cable connection for remote OIM or
VS Utilities.
DPI Port 5 Connection for an optional communications
module.
Power
Terminal Block
Connections for input and output power
wiring.
Signal and I/O
Terminal Block
Connections for signal and I/O wiring.
Figure 2.4 – Drive Connections (NEMA 1 Drives)
2
1or3
COMM PORT
CTRL BD
GND
UIB CONN
CONTROL/POWER CONN
WIRE
STRIP
CONTROL
POWER
Front View
Front View (Cover Removed)
Bottom View
Optional
Splitter Cable
(RECBL-SSP)
To Next Page
Loading...
