Rockwell Automation Reliance electric SP600 Series - 13.4 About Faults

Troubleshooting the Drive 13-5
13.3.1 Alarm Descriptions
Table 13.3 – Alarm Descriptions
Alarm
Type
Description
Analog In
Loss

An analog input is configured for alarm on signal loss and
signal loss has occurred.
Bipolar
Conflict

Parameter 190 (Direction Mode) is set to Bipolar or
Reverse Dis and one of more of the following digital input
functions is configured: Fwd/Rev, Run Fwd, Run Rev, Jog
Fwd, or Jog Rev.
Dig In
ConflictA

Digital input functions are in conflict. Combinations marked
with a will cause an alarm.
Dig In
ConflictB

Digital input functions are in conflict. Combinations marked
with a will cause an alarm.
Dig In
ConflictC

More than one physical input has been configured to the
same input function. Multiple configurations are not allowed
for the following input functions:
Acc2 /
Dec2
Accel 2 Decel 2 Jog Jog Fwd Jog Rev Fwd / Rev
Acc2 /
Dec2
Accel 2
Decel 2
Jog
Jog Fwd
Jog Rev
Fwd / Rev
Start Stop–CF Run Run Fwd Run Rev Jog Jog Fwd Jog Rev Fwd/Rev
Start
Stop–CF
Run
Run Fwd
Run Rev
Jog
Jog Fwd
Jog Rev
Fwd / Rev
Forward/Reverse Run Reverse Bus Regulation Mode B
Speed Select 1 Jog Forward Acc2 / Dec2
Speed Select 2 Jog Reverse Accel 2
Speed Select 3 OIM Control Decel 2
UserSetBit0 UserSetBit1