Rockwell Automation Reliance electric SP600 Series - 9 Using the LCD OIM; 9.1 Connections

Using the LCD OIM 9-1
CHAPTER 9
Using the LCD OIM
The LCD Operator Interface Module (OIM) is a keypad/display that
enables you to program, monitor, and control the drive.
9.1 Connections
The LCD OIM can be used in the following ways:
Drive mounted - The OIM connects directly to the drive using DPI
port 1.
Hand-held - A NEMA 4 remote-mount OIM is available. The
maximum cable length is 32 feet using extender cables. Connect
the cable to either DPI port 2 or 3.
Remote mounted - A NEMA 4 remote-mount OIM is available, or a
cable (RECBL-LCD) can be used to convert the standard OIM for
remote-mounted use (NEMA 1 drives only). The maximum cable
length is 32 feet using extender cables. Connect the cable to either
DPI port 2 or 3.
See figure 2.2 in chapter 2 for the connection points on the drive.
Figure 9.1 – SP600 LCD OIM
I
JOG
ESC
PROG
F1
F2
F3
F4
text
F1
ESC/
PROG
JOG
F2 F3 F4
o
I
Refer to section 9.3 for
the display description.
Refer to section 9.4 for the
key descriptions.
NEMA 1
NEMA 4