About the Drive
2-24
NEMA 4 Drives
The connector for the remote OIM or VS Utilities is located inside
the drive. You must route the cable through the bottom conduit holes
in the drive and connect it to DPI port 2 as shown in figure 2.6.
2.9 PC-Based Utility
The SP600 drive can be configured using a PC-based software
utility such as VS Utilities. This program enables you to upload and
download parameter configurations.
Figure 2.6 – DPI Port 2 on NEMA 4 Drives
Table 2.9 – PC-Based Utility Model Number and Instruction Manual Number
Description Model Number
Instruction
Manual
VS Utilities RECOMM-VSU232 D2-3488
Serial Converter for DPI Drives
(included with VS Utilities)
RECOMM-232 D2-3477
To Next Page
Loading...
