Rockwell Automation Reliance electric SP600 Series - Page 292

Index-2 SP600 AC Drive User Manual
Data Out B2 - Link B Word 2 (313), 12-78
Data Out C1- Link C Word 1 (314)
, 12-78
Data Out C2- Link C Word 2 (315)
, 12-78
Data Out D1- Link D Word 1 (316)
, 12-79
Data Out D2- Link D Word 2 (317)
, 12-79
Datalinks
, 2-12
DB Resistor Type (163)
, 12-46
DC Brake Level (158)
, 12-43
DC Brake Lvl Sel (157)
, 12-43
DC Brake Time (159)
, 12-44
DC Bus Memory (13)
, 12-7
DC Bus Voltage (12)
, 12-7
DC bus voltage measuring points
, 13-1,
13-2
Decel Time 1 (142)
, 12-38
Decel Time 2 (143)
, 12-38
derating guidelines
, A-8
device items, how to select
, 13-27
device version, how to determine
, 13-26
DeviceNet module
, 2-23
Dig In Status (216)
, 12-65
Dig Out Status (217)
, 12-66
Dig Out1 Level (381)
, 12-97
Dig Out1 OffTime (383)
, 12-97
Dig Out1 OnTime (382)
, 12-97
Dig Out2 Level (385)
, 12-100
Dig Out2 OffTime (387)
, 12-101
Dig Out2 OnTime (386)
, 12-100
Digital In1 Sel (361)
, 12-87
Digital In2 Sel (362)
, 12-87
Digital In3 Sel (363)
, 12-87
Digital In4 Sel (364)
, 12-87
Digital In5 Sel (365)
, 12-87
Digital In6 Sel (366)
, 12-87
Digital Out1 Sel (380)
, 12-95
Digital Out2 Sel (384)
, 12-98
digital outputs
, 2-7
Direction Mode (190)
, 12-53
display timeout period, setting
, 9-15
DPI interface
, 2-12
DPI ports
, 2-21
drive
connections (NEMA 1)
, 2-21
connections (NEMA 4)
, 2-22
control modes
, 2-8
derating guidelines
, A-8
features
, 2-7 to 2-17
installation site requirements
, 3-5
mounting
, 3-1 to 3-15
operation over wide speed
ranges
, 10-5
parameter descriptions
, 12-1 to
12-101
ratings
, 2-3 to 2-6
start/stop control
, 10-5
troubleshooting
, 13-1 to 13-28
wiring
, 4-1 to 4-12
Drive Alarm 1 (211)
, 12-63
Drive Alarm 2 (212)
, 12-63
Drive Checksum (203)
, 12-58
Drive Logic Rslt (271)
, 12-73
Drive OL Count (219)
, 12-66
Drive OL Mode (150)
, 12-39
Drive Ramp Rslt (273)
, 12-74
Drive Ref Rslt (272)
, 12-73
Drive Status 1 (209)
, 12-61
Drive Status 2 (210)
, 12-62
drive status parameters, accessing using
LCD OIM
, 13-25
Drive Temp (218)
, 12-66
Dyn UserSet Actv (206)
, 12-60
Dyn UserSet Cnfg (204)
, 12-59
dynamic braking
, 6-9 to 6-11
DynUsrSetSel (205)
, 12-59
E
Elapsed MWh (9), 12-6
Elapsed Run Time (10)
, 12-6
environmental conditions, meeting
, 3-5
EtherNet/IP module
, 2-23
external input disconnect
, 6-7
F
Fault Amps (225), 12-67
Fault Bus Volts (226)
, 12-67
Fault Clear (240)
, 12-71
Fault Clear Mode (241)
, 12-71
Fault Config 1 (238)
, 12-71
Fault Frequency (224)
, 12-67
fault queue
accessing using LCD OIM
, 13-24
time stamp
, 13-9
faults
about
, 13-7
clearing
, 13-10
descriptions and corrective
actions
, 13-11
fault parameters, accessing using
LCD OIM
, 13-24
fault queue
, 13-9
names cross-referenced by
numbers
, 13-17
types
, 13-8