Rockwell Automation Reliance electric SP600 Series - Page 7

Contents V
List of Figures
Figure 2.1 – Identifying the Drive by Model Number................................... 2-2
Figure 2.2 – Normal Mode Operation ....................................................... 2-14
Figure 2.3 – Dynamic Mode Operation..................................................... 2-16
Figure 2.4 – Drive Connections (NEMA 1 Drives) .................................... 2-21
Figure 2.5 – Drive Connections (NEMA 4 Drives) .................................... 2-22
Figure 2.6 – DPI Port 2 on NEMA 4 Drives............................................... 2-24
Figure 3.1 – Typical Jumper Locations (C Frame Shown).......................... 3-3
Figure 3.2 – Phase-to-Ground MOV Removal............................................ 3-4
Figure 3.3 – Minimum Mounting Clearances.............................................. 3-6
Figure 3.4 – Panel-Mount Drive Dimensions.............................................. 3-7
Figure 3.5 – Flange-Mount Drive Dimensions ............................................ 3-8
Figure 3.6 – SP600 IP20/ Nema Type 1 Bottom View Dimensions............ 3-9
Figure 3.7 – SP600 IP66 (NEMA Type 4X/12) Bottom View Dimensions 3-10
Figure 3.8 – SP600 Flange-Mount Bottom View Dimensions................... 3-11
Figure 3.9 – A-Frame Flange-Mount Cutout Dimensions......................... 3-12
Figure 3.10 – B-Frame Flange-Mount Cutout Dimensions....................... 3-13
Figure 3.11 – C-Frame Flange-Mount Cutout Dimensions....................... 3-13
Figure 3.12 – D-Frame Flange-Mount Cutout Dimensions....................... 3-14
Figure 3.13 – E-Frame Flange-Mount Cutout Dimensions....................... 3-14
Figure 4.1 – How to Calculate Motor Lead Lengths.................................... 4-6
Figure 4.2 – Inverter and Motor Line-to-line Voltages................................. 4-7
Figure 4.3 – Motor Overvoltage as a Function of Cable Length................. 4-8
Figure 5.1 – Typical Wire Routing and Terminal Block Locations
(5 HP Drive Shown) ............................................................. 5-2
Figure 5.2 – Typical Grounding................................................................... 5-3
Figure 5.3 – Single-Point Grounding/Panel Layout..................................... 5-3
Figure 6.1 – Removing the Drive Cover (NEMA 1 Drives).......................... 6-2
Figure 6.2 – Removing the Drive Cover (NEMA 4x/12 Drives)
Frames B4 and D4 shown. .................................................. 6-3
Figure 6.3 – Installing Plugs in Unused Holes in Conduit Entry Plate
on NEMA 4X/12 Drives........................................................ 6-4
Figure 6.4 – Location of Slots for User-Supplied Locks
on NEMA 4x/12 Drives......................................................... 6-4
Figure 6.5 – Power Terminal Block............................................................. 6-8
Figure 6.6 – Power Input Terminals on the Internal RFI Filter Option ........ 6-8
Figure 6.7 – Simplified Dynamic Braking Schematic.................................. 6-9
Figure 6.8 – Protective Circuit for External Resistor Packages................ 6-10
Figure 7.1 – I/O Wiring Diagram ................................................................. 7-7
Figure 7.2 – Wiring Diagram: Default Drive Configuration.......................... 7-9