1. Selective Programming / Erasure of 01 to 30 user codes („master user’s
submenus” from [01] to [30]);
2. Simultaneous Erasure of all user codes, except the „master code” („master user’s
submenu” [49]);
3. Selective Programming / Erasure of the follow me phone numbers („master
user’s submenus” from [51] to [54]);
4. Simultaneous Erasure of all follow me phone numbers („master user’s submenu”
[50]);
5. Programming session of the system date and hour („master user’s submenu”
[60]).
6. „Ambush Digit Programming” („master user’s submenu” [61]).
While the system is within „master user’s programming menu”, in order to program the 01
to 30 user codes, the follow me phone numbers, the system date and hour or the
„ambush digit”, select one of the [01] to [30], [49], [50], [51] to [54], [60] or [61]
„master user’s submenus”. To enter each „master user’s submenu” the master user should
enter 2 digits which are corresponding to the order number of each submenu (i.e. for
submenu no. 9 press [0] and [9] keys).
After entering the 2 digits corresponding to the order number of one submenu, the keypad
buzzer will beep for 3 times, confirming the system is within respective submenu.
Once the system was entering one of the „master user’s submenus”, the keypad LEDs’ status will be as
follows:
Means the selected user code, the follow me phone number or the system date
and hour were programmed during a previous programming session.
Means the selected user code, the follow me phone number or the system date
and hour are not programmed.
PROGRAMMING / SELECTIVE ERASURE (EXCEPT THE „MASTER CODE”) OF 01 TO 30 USER CODES
[*][7][Master Code] or [CODE][Master Code],
where [CODE] is the key labeled “CODE”
The [*][7][Master Code] or [CODE][Master Code] commands allow to the „master user” to
modify all user codes.
While the system is within „master user’s programming menu”, in order to program /
erase any of 01 to 30 user codes, select the corresponding submenu from [01] to
[30], by pressing the 2-digit order number of the user code to be programmed / erased (i.e.
while the system is within „master user’s programming menu”, for user code no. 30 press [3]
and [0] keys).
Then enter the following sequence:
[x][x][x][x] |RIGHTS||#|
where [x][x][x][x] are the new 4 digits for the „selected user code” and RIGHTS are its set of
rights.
While the system is within programming / erasing session of the „selected user code”, the keypad
LEDs’ status will be as follows:
Means the „selected user code” was programmed during a previous
programming session and the control panel is waiting for the first digit
To Next Page
Loading...
