TECHNICAL SPECIFICATIONS
Number of zones 5 zones
Zone type programmable
EOL Resistor 3.3K ohm
2 EOL Resistors 2.2K + 1K
Programmable outputs: PGM 1 and PGM 2 2
Load for PGM1 and PGM2 outputs up to 50mA
Main board typical consumption 50mA
LED keypad typical consumption 12mA
Power current for battery charging up to 100mA
Board operation rated voltage 14.2 Vdc +/- 0.2 Vdc
+AUX fuse (Cerber C52) 1.25A
+BELL fuse (Cerber C52) 1.25A
+AUX maximum current (Cerber C82) 2.5A – fuse-less
+BELL maximum current (Cerber C82) 2.5A – fuse-less
Note: For Cerber C52 control panels, use the indicated rate fuses, or the control panel’s board
may be damaged by short-circuits on +AUX and/or +BELL outputs.
To Next Page
Loading...
