1. No right is enabled for the installer’s code.
2. The „installer’s code” erasing isn’t allowed. If, by mistake, one is trying to erase the installer’s code, by
entering [*] key instead of the 4-digits code, the keypad buzzer will sound a long rejection beep and the
panel will go back within “main programming menu” and will keep the old value for the „installer’s code”.
3. The default value for the “installer’s code” is “0269”.
Remember! After completing the alarm system installation and programming, installer should:
1. Change the default value of the installer’s code;
2. Keep good record of the code for later use, especially if the parameter “protection against unwanted
resets to default values” has been set as enabled.
SECTION [50] – MASTER CODE PROGRAMMING, PERFORMED BY INSTALLER
While the panel is within the “main programming menu”, select section [50] in order to
program the master code, then enter the following sequence:
[x][x][x][x] |RIGHTS||#|, where [x][x][x][x] are the new 4 digits for the master code and
RIGHTS are its set of rights.
While the system is section [50], the keypad LEDs’ status will be as follows:
Means the master code is programmed and the control panel
is waiting for the first digit entering (the master code is
always programmed).
One of the 2 to 4 zone LEDs
Means the master code is programming and the control
panel is waiting for the corresponding digit.
1. The master code programming may be skipped by [#] key pressing. After [#] key
pressing, the keypad buzzer will sound 3 confirmation beeps and the system will pass to
display the master code rights (step no. 3).
2. In order to program the master code, you should enter the following sequence
from the keypad:
[x][x][x][x], where [x][x][x][x] are the new 4 digits for the master code.
2.1 After entering the first digit the zone 2 LED will blink. Means the control panel is
waiting for the second digit.
2.2. After entering second digit the zone 3 LED will blink. Means the control panel is
waiting for the third digit.
2.3. After entering third digit the zone 4 LED will blink. Means the control panel is
waiting for the fourth digit.
2.4. After any digit was pressed, master code programming may be canceled by [#]
key pressing. After cancellation by [#] key pressing, the keypad buzzer will sound 6
confirmation beeps, the system will keep the old value for the master code and the control
panel will go back within “main programming menu”.
Note: Do not press [*] key while entering the digits of the master code! The keypad buzzer will sound a long error
beep, will reject [*] key and will go back within “main programming menu”.
3. After entering the last digit of the master code the keypad buzzer will sound 3
confirmation beeps and the panel will pass to the next step, displaying on zone 1 to 7 LEDs
the master code rights, as follows:
Keypad LEDs’ status while the system is within displaying submenu of the master
code rights:
To Next Page
Loading...
