Rohde & Schwarz FSEA20 - Page 127

CONFigure-Subsystem FSE
1065.6016.12 6.70 E-16
:CONFigure[:BTS]:POWer:SINGle:CLEar
This command clears the table containing the single-step carrier power measurements.
Example: ":CONF:POW:SING:CLE"
Feature: *RST value: --
SCPI: device-specific
Mode: BTS
This command is an event and has therefore neither *RST value nor query.
:CONFigure[:BTS]:CHANnel:SLOT 0 to 7
This command selects the slot number within a transmission frame of the base station.
Example: ":CONF:CHAN:SLOT 3"
Features: *RST value: 0
SCPI: device-specific
Mode: BTS
On changing the slot number, the number of the midamble (TSC) is automatically adapted to the slot.
:CONFigure[:BTS]:CHANnel:SLOT:AUTO ONCE
This command automatically searches for the slot number within a transmission frame of the base
station. This requires only one slot to be active.
Example: ":CONF:CHAN:SLOT:AUTO ONCE"
Features: *RST value: --
SCPI: device-specific
Mode: BTS
This command is an event and thus has no query and no *RST value assigned.
:CONFigure[:BTS]:CHANnel:SFH ON | OFF
This command defines whether the base station uses slow frequency hopping or not.
Example: ":CONF:CHAN:SFH ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: BTS
This command is available only when spurious or transient spectrum measurement is selected. The
settings for spurious measurement are independent from those selected for transient spectrum.