FSE CONFigure-Subsystem
1065.6016.12 6.71 E-16
:CONFigure[:BTS]:CHANnel:TSC:AUTO ON | OFF
This command couples the midamble (training sequence TSC_0 to 7) to the slot, i.e. if the slot
number is changed the training sequence in the ON state is automatically adapted. In the OFF state,
the training sequence set is conserved even if the slot number is changed.
Example: ":CONF:CHAN:TSC:AUTO ON"
Features: *RST value: ON
SCPI: device-specific
Mode: BTS
:CONFigure[:BTS]:CHANnel:TSC 0 to 7
This command selects the midamble (training sequence TSC_0 to 7) of the active slot.
Example: ":CONF:CHAN:TSC 3"
Features: *RST value: 0
SCPI: device-specific
Mode: BTS
:CONFigure[:BTS]:NETWork[:TYPE] PGSM | PGSM900 | EGSM | EGSM900 | DCS |GSM1800 |
PCS | GSM1900 | RGSM | RGSM900 | GSM850
This command selects the standard type according to which the base station will work.
Example: ":CONF:NETW DCS"
Features: *RST value: GSM
SCPI: device-specific
Mode: BTS
:CONFigure[:BTS]:NETWork:PHASe 1|2 [,PLUS]
This command selects the phase of the standard according to which the base station will work.
Example: ":CONF:NETW:PHAS 2"
Features: *RST value: 1
SCPI: device-specific
Mode: BTS
:CONFigure[:BTS]:COSiting ON | OFF
This command selects whether the base station has the "cositing" feature.
Example: ":CONF:COS ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: BTS
This command is available only if spurious emission measurement is selected.
To Next Page
Loading...
