CONFigure-Subsystem FSE
1065.6016.12 6.76 E-16
:CONFigure:BURSt:PTEMplate:SELect FULL | TOP | RISing | FALLing
This command defined the burst section to be measured.
Example: ":CONF:BURS:PTEM:SEL TOP"
Features: *RST value: FULL
SCPI: device-specific
Modes: BTS, MS
:CONFigure:BURSt:REFerence:AUTO ON | OFF
This command switches between automatic and user-activated preview of power versus time. When
switched to AUTO, the preview is always performed, when switched to OFF it is omitted. Note: see
READ:BURSt:REF:IMM
Example: ":CONF:BURS:REF:AUTO ON"
Feature: *RST value: AUTO
SCPI: device-specific
Mode: BTS, MS
To Next Page
Loading...
