CONFigure-Subsystem FSE
1065.6016.12 6.82 E-16
:CONFigure[:MS]:POWer:SINGle[:STATe] ON | OFF
This command switches single measurement of carrier power on and off.
Example: ":CONF:POW:SING ON"
Feature: *RST value: OFF
SCPI: device-specific
Mode: MS
:CONFigure[:MS]:POWer:SINGle:CLEar
This command clears the table containing the single-step carrier power measurements.
Example: ":CONF:POW:SING:CLE"
Feature: *RST value: --
SCPI: device-specific
Mode: MS
This command is an event and has therefore neither *RST value nor query.
:CONFigure[:MS]:POWer:SMALl ON | OFF
This command switches the limits for spurious measurement in the RGSM range. It is only available
for phase 2+.
Example: ":CONF:POW:SMAL ON"
Feature: *RST value: OFF
SCPI: device-specific
Mode: MS
:CONFigure[:MS]:CHANnel:SFH ON | OFF
This command switches slow-frequency hopping on or off.
Example: ":CONF:CHAN:SFH ON"
Feature: *RST value: OFF
SCPI: device-specific
Mode: MS
:CONFigure[:MS]:CHANnel:TSC 0 to 7
This command selects the midamble used by the mobile.
Parameter: 0 to 7 (training sequence for the Normal Burst)
Example: ":CONF:CHAN:TSC 3"
Features: *RST value: 0
SCPI: device-specific
Mode: MS
To Next Page
Loading...
