FSE CONFigure-Subsystem
1065.6016.12 6.83 E-16
:CONFigure[:MS]:NETWork[:TYPE] PGSM | PGSM900 | EGSM |EGSM900 | DCS |GSM1800 |
PCS|GSM1900 | RGSM | RGSM900 | GSM850
This command selects the standard type according to which the mobile will work.
Example: ":CONF:NETW DCS"
Features: *RST value: GSM
SCPI: device-specific
Mode: MS
:CONFigure[:MS]:NETWork:PHASe 1 | 2 [,PLUS]
This command selects the phase of the standard according to which the mobile will work.
Example: ":CONF:NETW:PHAS 2"
Features: *RST value: 1
SCPI: device-specific
Mode: MS
:CONFigure[:MS]:TXSupp ON | OFF
This command defines that an additional carrier suppression of min. 20dB is taken into account for
the measurement. If there is already suppression, a more sensitive setting of the instrument is
selected.
Example: ":CONF:TXS ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: MS
For measurements in the RX-band the value is automatically set to ON.
:CONFigure[:MS]:PRESet
This command resets the parameters for the standard selected to their default values (DEFAULT
SETTINGS).
Example: ":CONF:PRES"
Features: *RST value: --
SCPI: device-specific
Mode: MS
This command is an event and has thus no query and no *RST value assigned.
To Next Page
Loading...
