CONFigure-Subsystem FSE
1065.6016.12 6.84 E-16
:CONFigure[:MS]:SWEeptime STANdard | AUTO
This command selects the sweep-time computing mode for the spurious measurement:
Example: ":CONF:SWE AUTO"
Feature: *RST value: STANdard
SCPI: device-specific
Mode: MS
STANdard The computation of the sweep time is based on a worst-case estimation
AUTO The sweep time is reduced by a factor of 8 (assuming all slots are on).
:CONFigure[:MS]:MTYPe GMSK | EDGE
This command selects the standard (GMSK or EDGE).
Example: ":CONF:MTYP EDGE"
Features: *RST value: GMSK
SCPI: device-specific
Mode: MS
To Next Page
Loading...
