Rohde & Schwarz FSEA20 - Page 143

CONFigure-Subsystem FSE
1065.6016.12 6.86 E-16
:CONFigure:SPECtrum:MODulation:RANGe ARFCn | TXBand | RXBand | COMBined | DCSRx1800
| G8Rxband | PCSRx1900
This command selects the frequency range for the measurement.
Example: ":CONF:SPEC:MOD:RANG TXB"
Features: *RST value: ARFCn
SCPI: device-specific
Modes: BTS, MS
ARFCn ARFCN ± 1.8 MHz
TXBand TX-Band
RXBand RX-Band
COMBined ARFCN ± 1.8 MHz / TX-Band
DCSRx1800 RX band DCS 1800 (option FSE-K10 only)
G8Rxband RX band GSM 850 (option FSE-K10 only)
PCSRx1900 RX band PCS 1900 (option FSE-K10 only)
:CONFigure:SPECtrum:MODulation:TGATe ON | OFF
This command switches on or off the operating mode gating for the TX band. For TGATe OFF, 8
active slots are presumed.
Example: ":CONF:SPEC:MOD:TGAT ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:BTS
:CONFigure:SPECtrum:SWITching[:IMMediate]
This command selects measurement of the spectrum due to switching transients.
Example: ":CONF:SPEC:SWIT"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
This command is an event and has thus no query and no *RST value assigned.
:CONFigure:SPECtrum:SWITching:COUNt 1 to 1000
This command defines the number of bursts used for determining the average and maximum values.
Example: ":CONF:SPEC:SWIT:COUN 100"
Features: *RST value: 500 (GSM/DCS1800 phase I)
200 otherwise
SCPI: device-specific
Modes: BTS, MS