Rohde & Schwarz FSEA20 - Page 144

FSE CONFigure-Subsystem
1065.6016.12 6.87 E-16
CONFigure:SPURious Subsystem
This subsystem provides commands for configuring the measurements in the GSM BTS (FSE-K11) or
GSM MS (FSE-K10) Analyzer mode used for measuring the power of spurious emissions.
COMMAND PARAMETERS UNIT COMMENT
CONFigure
:SPURious
[:IMMediate]
:COUNt
:RXBand
:RANGe
:STEP<1..26>
:COUNt?
:ANTenna
--
<numeric_value>
<numeric_value>
TXBand | OTXBand | RXBand |
IDLeband | COMBined
<Boolean>
CONDucted | RADiated
--
--
--
--
--
no query, Option FSE-K11, FSE-K10
Option FSE-K11, FSE-K10
Option FSE-K11
Option FSE-K11, FSE-K10
Option FSE-K11, FSE-K10
query only
Option FSE-K10
:CONFigure:SPURious[:IMMediate]
This command selects measurement of spurious emissions.
Example: ":CONF:SPUR"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
This command is an event and has thus no query and no *RST value assigned.
:CONFigure:SPURious:COUNt 1 to 1000
This command sets the number of bursts used for determining the average and maximum values.
Example: ":CONF:SPUR:COUN 100"
Features: *RST value: 500 (GSM/DCS1800 phase I)
200 otherwise
SCPI: device-specific
Modes: BTS, MS
The number of bursts in measurements of the RX band is set by command
:CONFigure:SPURious:RANGe:RXBand (FSE K11 only).
:CONFigure:SPURious:COUNt:RXBand 1 to 1000
This command ses the number of bursts used for determining the average and maximum values in
measurements of the RX band.
Example: ":CONF:SPUR:COUN:RXB 100"
Features: *RST value: 1
SCPI: device-specific
Modes: BTS