FETCh-Subsystem FSE
1065.6016.12 6.114 E-16
:FETCh:SPECtrum:SWITching[:ALL]?
This command reads out the result of the measurement of the transient spectrum of the base station
or mobile.
Parameter: The result is output as a list of partial result strings separated by ’,’ as for the
command :FETCh:SPECtrum:MODulation[:ALL]?.
Example: ":FETC:SPEC:SWIT?"
Result: 0,833.4E6,833.4E6,37.4,-36.0,ABS,MARGIN,
1,834.0E6,834.0E6,-35.2,-36.0,ABS,FAILED,
2,834.6E6,834.6E6,-74.3,-75.0,REL,FAILED
0,835.0E6,835.0E6,-65,0,-60.0,REL,PASSED
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the transient spectrum is selected (see :CONFigure:SPECtrum:SWITching).
:FETCh:SPECtrum:SWITching:REFerence?
This command queries the result of the premeasurement
Parameter: The result is output as a list of partial result strings separated by ’,’ in the following
(ASCII) format:
<Level1>,<Level2>,<RBW>
<Level1>: measured level
<Level2>: level corrected by means of the bandwidth
<RBW>: bandwidth
Example: ":FETC:SPEC:SWIT:REF?"
Result: 43.2,43.2,300000
Features: *RST value --
SCPI: device specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the transient spectrum is selected (see :CONFigure:SPECtrum:SWITching).
To Next Page
Loading...
