FSE MMEMory Subsystem
1065.6016.12 6.139 E-16
:MMEMory:SELect[:ITEM]:HWSettings ON | OFF
This command includes the hardware settings in the list of data subsets of a device setting to be
stored/loaded.
Example: ":MMEM:SEL:HWS ON"
Features: *RST value: ON
SCPI: device-specific
Modes: A, VA, BTS, MS
Level and frequency lines are stored with this command as well.
:MMEMory:SELect[:ITEM]:TRACe<1 to 4> ON | OFF
This command includes the data of the selected trace in the list of data subsets of a device setting to
be stored/loaded.
Example: ":MMEM:SEL:TRACE3 ON"
Features: *RST value: OFF for all Traces
SCPI: device-specific
Modes: A, VA, BTS, MS
:MMEMory:SELect[:ITEM]:LINes[:ACTive] ON | OFF
This command includes the active limit lines in the list of data subsets of a device setting to be
stored/loaded.
Example: ":MMEM:SEL:LIN ON"
Features: *RST value: ON
SCPI: device-specific
Modes: A, VA, BTS, MS
Upon MMEM:LOAD the limit lines which are not currently active but contained in the data set are
restored as well.
:MMEMory:SELect[:ITEM]:LINes:ALL ON | OFF
This command includes all limit lines in the list of data subsets of a device setting to be
stored/loaded.
Example: ":MMEM:SEL:LIN:ALL ON"
Features: *RST value: ON
SCPI: device-specific
Modes: A, VA, BTS, MS
This command includes selection of the active limit lines.
To Next Page
Loading...
