Rohde & Schwarz FSEA20 - Page 202

FSE READ-Subsystem
1065.6016.12 6.145 E-16
READ Subsystem
The READ-subsystem contains commands for starting complex measurement tasks such as those
provided by options GSM BTS Analyzer (FSE-K11) or GSM MS Analyzer (FSE-K10), and for querying
the results subsequently. The READ-subsystem is closely linked to the functions of the CONFigure- and
FETCh-subsystems, where the measurement sequences are configured or the results are queried
without restarting a new measurement.
READ:BURSt Subsystem
This subsystem provides the commands for starting measurements in the GSM BTS Analyzer mode
(option FSE-K11), which are performed on individual bursts (carrier power, phase/frequency error), and
for reading out the results subsequently.
COMMAND PARAMETERS UNIT COMMENT
READ
:BURSt
:PERRor
:RMS
:STATus?
:AVERage?
:MAXimum?
:PEAK
:STATus?
:AVERage?
:MAXimum?
:FERRor
:STATus?
:AVERage?
:MAXimum?
:POWer?
:STATic?
:DYNamic?
:LEVel?
:REFerence
[:IMMediate]?
:MACCuracy
:RMS
:STATus?
:AVERage?
:MAXimum?
:PEAK
:STATus?
:AVERage?
:MAXimum?
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Option FSE-K11 or FSE-K10
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only; FSE-K11 only
query only; FSE-K11 only
query only; FSE-K10 only
query only
query only
query only
query only
query only
query only
query only