FSE SENSe Subsystem
1065.6016.12 6.173 E-16
:[SENSe<1|2>:]CORRection:TRANsducer:CATalog?
This command reads out the names of all transducer factors stored on the harddisk.
Syntax of output format:
<Sum of file lengths of all subsequent files>,<free memory on hard disk>,
<1st file name>,,<1st file length>,<2nd file name>,,<2nd file length>,....,<nth file name>,
<nth file length>
Example: ":CORR:TRAN:CAT?"
Feature: *RST value: -
SCPI: device-specific
Mode: A
:[SENSe<1|2>:]CORRection:TRANsducer:ACTive?
This command reveals the active transducer factor. If no transducer factor is switched on, a void
string will be output.
Example: ":CORR:TRAN:ACT?"
Feature: *RST value: -
SCPI: device-specific
Mode: A
:[SENSe<1|2>:]CORRection:TRANsducer:SELect <name>
This command selects the transducer factor designated by <name>. If <name> does not exist yet, a
new transducer factor is created.
Parameter: <name>::= Name of the transducer factor in string data form with a
maximum of 8 characters.
Example: ":CORR:TRAN:SEL ’FACTOR1’"
Features: *RST value: -
SCPI: device-specific
Mode: A
This command must be sent prior to the subsequent commands for modifying/activating transducer
factors.
:[SENSe<1|2>:]CORRection:TRANsducer:UNIT <string>
This command defines the unit of the transducer factor selected.
Parameter: <string>::= ’DB’ | ’DBM’ | ’DBMV’ | ’DBUV’ | ’DBUV/M’ | ’DBUA’
’DBUA/M’ | ’DBPW’ | ’DBPT’
Example: ":CORR:TRAN:UNIT ’DBUV’"
Features: *RST value: ’DB’
SCPI: device-specific
Mode: A
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
To Next Page
Loading...
