Rohde & Schwarz FSEA20 - Page 241

SENSe Subsystem FSE
1065.6016.12 6.184 E-16
:[SENSe<1|2>:]DDEMod:MSK:FORMat TYPE1 | TYPE2 | NORMal | DIFFerential
This command determines the specific demodulation type for MSK.
Example: ":DDEM:MSK:FORM TYPE2"
Features: *RST value: TYPE2 | DIFFerential
SCPI: device-specific
Mode: VA-D
TYPE1 | NORMal corresponds to MSK demodulation, TYPE2 | DIFFerential corresponds to
DMSK demodulation.
:[SENSe<1|2>:]DDEMod:QAM:NSTate 16
This command determines the specific demodulation type for QAM.
Example: ":DDEM:QAM:NST 16"
Features: *RST value: 16
SCPI: device-specific.
Mode: VA-D
:[SENSe<1|2>:]DDEMod:FSK:NSTate 2 | 4
This command determines the specific demodulation type for FSK.
Example: ":DDEM:FSK:NST 2"
Features: *RST- value: -
SCPI: device-specific
Mode: VA-D
The parameter 2 corresponds to the demodulation type 2FSK, the parameter 4 to the demodulation
type 4FSK.
:[SENSe<1|2>:]DDEMod:SRATe 160 Hz to 1.6 MHz
This command defines the symbol rate.
Example: ":DDEM:SRAT 18kHz"
Features: *RST value: 270.833333kHz
SCPI: device-specific
Mode: VA-D
:[SENSe<1|2>:]DDEMod:TIME 1 to Frame Length
The command determines the number of displayed symbols (result length).
Example: ":DDEM:TIME 80"
Features: *RST value: 147
SCPI: device-specific
Mode: VA-D