Rohde & Schwarz FSEA20 - Page 78

FSE CALCulate Subsystem
1065.6016.12 6.21 E-16
COMMAND PARAMETERS UNIT COMMENT
CALCulate<1|2>
:LIMit<1 to 8>
:COMMent
:COPY
:NAME
:DELete
:BURSt
:PTEMplate?
:POWer?
:PFERror?
:MACCuracy?
:SPECtrum
:MODulation?
:FAILs?
:EXCeptions?
:SWITching?
:FAILs?
:SPURious?
:FAILs?
:MARGin
:ACPower
[:STATe]
:ACHannel
:STATe
:RESult?
:ALTernate<1|2>
:STATe
:RESult?
<string>
1 to 8 | < name>
<string>
--
--
--
--
--
--
ARFCn | TXBand | RXBand |
COMBined | DCSRx1800
ARFCn | TXBand | RXBand |
COMBined | DCSRx1800
ARFCn | TXBand | RXBand |
COMBined | DCSRx1800
TXBand | OTXBand | RXBand |
IDLeband
TXBand | OTXBand | RXBand |
IDLeband
<numeric_value>
<Boolean>
<numeric_value>, <numeric_value>
<Boolean>
--
<numeric_value>, <numeric_value>
<Boolean>
--
DB
DB; DB
DB; DB
Option FSE-K11 or FSE-K10
query only
query only
query only
query only, option FSE-K20/K21
Option FSE-K11 or FSE-K10
query only
query only
query only
query only; Option FSE-K11or FSE-K10
query only
query only; Option FSE-K11 or FSE-K10
query only
query only
query only
:CALCulate<1|2>:LIMit<1 to 8>:ACTive?
This command queries the names of all activated limit lines. The names are output in alphabetical
order. If no limit line is activated, an empty string will be output. The numeric suffixes in
CALCulate<1|2> and LIMit<1 to 8> are not significant.
Example: ":CALC:LIM:ACT?"
Features: *RST value: -
SCPI: device-specific
Mode: A, VA, BTS, MS
:CALCulate<1|2>:LIMit<1 to 8>:TRACe 1 to 4
This command assigns a trace to a limit line.
Example: ":CALC:LIM2:TRAC 2"
Features: *RST value: 1
SCPI: device-specific
Modes: A, VA, BTS, MS