CALCulate Subsystem FSE
1065.6016.12 6.30 E-16
:CALCulate<1|2>:LIMit<1 to 8>:BURSt:MACCuracy?
This command queries the total result of the modulation accuracy measurement.
Parameter: 1 limit not exceeded
0 limit exceeded
Example: ":CALC:LIM:BURS:MACC?"
Result:1
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
This command is a query and therefore not assigned a *RST value.
If the command is triggered off before the cphase-frequency measurement was started for the first
time, a query error results. The numeric suffixes <1|2> or <1 to 8> are not significant for this
command. This command is only available in conjunction with option FSE-K20 / FSE-K21 .
:CALCulate<1|2>:LIMit<1 to 8>:SPECtrum:MODulation? ARFCn | TXBand | RXBand | COMBined |
DCSRx1800
This command queries the total result of the spectrum due to modulation measurement for list mode.
For frequency mode, the limit violations are queried with command CALCulate:LIMit:FAIL?.
Parameter: The result is displayed in character data form. Possible values are:
PASSED limit not exceeded
FAILED limit exceeded
ABORTED measurement aborted
RUNNING measurement not completed
Examples: ":CALC:LIM:SPEC:MOD? RXB"
Result: PASSED
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
ARFCn ARFCN ± 1.8 MHz TXBand TX-band
RXBand RX-band COMBined ARFCN ± 1.8 MHz / TX-band
DCSRx1800 RX-Band DCS 1800 (option FSE-K10 only)
This command is a query and therefore not assigned a *RST value.
The numeric suffixes <1|2> or <1 to 8> are not significant for this command.
To Next Page
Loading...
