FSE CALCulate Subsystem
1065.6016.12 6.31 E-16
:CALCulate<1|2>:LIMit<1 to 8>:SPECtrum:MODulation:FAILs? ARFCn | TXBand | RXBand |
COMBined | DCSRx1800
This command queries the number of limit violations of the spectrum due to modulation
measurement for list mode.The number of limit violations is the total of all violations above and below
the carrier. For frequency mode, the limit violations are queried with command
CALCulate:LIMit:FAIL?.
Examples: ":CALC:LIM:SPEC:MOD:FAIL? RXB"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
ARFCn ARFCN ± 1.8 MHz
TXBand TX-band
RXBand RX-band
COMBined ARFCN ± 1.8 MHz / TX-band
DCSRx1800 RX-Band DCS 1800 (option FSE-K10 only)
This command is a query and therefore not assigned a *RST value
The numeric suffixes <1|2> or <1 to 8> are not significant for this command.
:CALCulate<1|2>:LIMit<1 to 8>:SPECtrum:MODulation:EXCeptions? ARFCn | TXBand | RXBand |
COMBined | DCSRx1800
This command queries the number of limit violations of the spectrum due to modulation
measurement which are marked as exceptions. This command is only available for list mode.
Examples: ":CALC:LIM:SPEC:MOD:EXC? RXB"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
ARFCn ARFCN ± 1.8 MHz
TXBand TX-band
RXBand RX-band
COMBined ARFCN ± 1.8 MHz / TX-band
DCSRx1800 RX-Band DCS 1800 (option FSE-K10 only
This command is a query and therefore not assigned a *RST value. The numeric suffixes <1|2> or
<1 to 8> are not significant for this command.
To Next Page
Loading...
