Rohde & Schwarz FSW-K40 - Page 151

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
151User Manual 1173.9286.02 ─ 15
Bit no Meaning
3 to 14 Unavailable for phase noise measurements.
15 This bit is always 0.
8.15.1.5 Status Register Remote Commands
STATus:OPERation[:EVENt]?......................................................................................... 151
STATus:QUEStionable[:EVENt]?.....................................................................................151
STATus:QUEStionable:LIMit[:EVENt]?.............................................................................151
STATus:QUEStionable:PNOise[:EVENt]?.........................................................................151
STATus:QUEStionable:POWer[:EVENt]?......................................................................... 151
STATus:OPERation:CONDition?..................................................................................... 152
STATus:QUEStionable:CONDition?.................................................................................152
STATus:QUEStionable:LIMit:CONDition?.........................................................................152
STATus:QUEStionable:PNOise:CONDition?.....................................................................152
STATus:QUEStionable:POWer:CONDition?..................................................................... 152
STATus:OPERation:ENABle........................................................................................... 152
STATus:QUEStionable:ENABle.......................................................................................152
STATus:QUEStionable:LIMit:ENABle...............................................................................152
STATus:QUEStionable:PNOise:ENABle...........................................................................152
STATus:QUEStionable:POWer:ENABle........................................................................... 152
STATus:OPERation:NTRansition.....................................................................................152
STATus:QUEStionable:NTRansition................................................................................ 152
STATus:QUEStionable:LIMit:NTRansition........................................................................ 152
STATus:QUEStionable:PNOise:NTRansition.................................................................... 152
STATus:QUEStionable:POWer:NTRansition.....................................................................152
STATus:OPERation:PTRansition.....................................................................................153
STATus:QUEStionable:PTRansition.................................................................................153
STATus:QUEStionable:LIMit:PTRansition.........................................................................153
STATus:QUEStionable:PNOise:PTRansition.....................................................................153
STATus:QUEStionable:POWer:PTRansition..................................................................... 153
STATus:OPERation[:EVENt]?
STATus:QUEStionable[:EVENt]?
STATus:QUEStionable:LIMit[:EVENt]? <ChannelName>
STATus:QUEStionable:PNOise[:EVENt]? <ChannelName>
STATus:QUEStionable:POWer[:EVENt]? <ChannelName>
These commands read out the EVENt section of the status register.
The commands at the same time delete the contents of the EVENt section.
Query parameters:
<ChannelName> String containing the name of the channel.
The parameter is optional. If you omit it, the command works for
the currently active channel.
Usage: Query only
Using the Status Register