Roland JUNO-D6 - Saving a Tone;Drum Kit (TONE WRITE;DRUM WRITE); Saving the System Settings (SYSTEM WRITE)

33
Saving the settings (WRITE)
Data saved as a scene
The following settings and data are saved in a scene.
¹ Settings for the overall scene (scene parameters)
¹ Settings for each part (part parameters)
¹ Arpeggio settings
¹ Chord memory settings
¹ Rhythm pattern group settings
¹ Vocoder settings
¹ Step sequencer data
¹ Eect settings
Saving a tone/drum kit (TONE WRITE/
DRUM WRITE)
Changes that you make to the tones/drum kits are temporary. If you
turn o the power or select another tone/drum kit, the changes are
lost.
If you want to keep your changes, use the write operation for the
tone or drum kit.
NOTE
When you save, the data previously located in the save-
destination is overwritten.
1. Select the tone/drum kit for the part you want to
save (p. 17), and press the [WRITE] button.
The WRITE screen appears.
2. Move the cursor to “TONE WRITE” or “DRUM WRITE”
and press the [ENTER] button.
The TONE WRITE screen or the DRUM WRITE screen appears.
TONE WRITE
DRUM WRITE
3. To change the name, input the characters by
following the instructions shown at the bottom of
the screen.
4. Once you’ve entered the name, press the [ENTER]
button.
5. Use the value dial to select the save destination,
and press the [ENTER] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
6. Move the cursor to “WRITE” and press the [ENTER]
button.
This saves the tone or the drum kit.
NOTE
Never turn o the power while the screen indicates “Processing...”.
Saving the system settings (SYSTEM
WRITE)
To store the system settings you edited, perform the system write
operation.
1. On the WRITE screen, move the cursor to “SYSTEM
WRITE” and press the [ENTER] button.
You can also press the [WRITE] button while the
SYSTEM EDIT screen is shown.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
2. Move the cursor to “WRITE” and press the [ENTER]
button.
The screen indicates “Completed” when the settings are changed.
NOTE
Never turn o the power while the screen indicates “Processing...”.