4
Placing this instrument on a stand
NOTE
Take sucient care not to get your ngers or other body parts pinched when setting up the stand. Place this instrument on the stand as shown
below.
If you want to place the XPS-60 on a stand, use the Roland KS-11Z, KS-13 or KS-20X.
KS-11Z
Align the front of
the XPS-60 with
the front of the
stand.
Adjust the width of the stand so
that the stand arms are lined up
between the rubber feet of the
XPS-60.
Top view
Adjust the stand width
KS-13
Adjust the stand width so that
the rubber feet on the keyboard
side (front) of the XPS-60 t into
the holes provided on the stand.
Top view
Adjust the stand width
KS-20X
Line up the
XPS-60 so
that it rests
on the rubber
rings of the
stand.
Open the stand to its lowest position
(the folded-up position is “1”; the height
adjustment cam should be locked into
the sixth groove).
Align the middle of the XPS-60 with the center of the stand
To Next Page
Loading...
