Roland JUNO-D6 - Assigning Functions to the SOUND MODIFY Knobs; Editing the Assigned Parameters in System Settings; Editing Assigned Parameters in the Scene Settings; Editing the Setting Source of the Assigned Parameters

43
Assigning functions to the SOUND MODIFY knobs
You can assign various functions to the [1]–[4] knobs. By doing this, you can press the [KNOB ASSIGN] button for control over the parameters that
are assigned to the [1]–[4] knobs.
The parameters you assign can be saved as system settings or as scene settings, and you can use either setting for the respective knobs.
Editing the assigned parameters in system
settings
1. Press the [MENU] button.
The MENU screen appears.
2. Move the cursor to “SYSTEM EDIT” and press the
[ENTER] button.
The SYSTEM EDIT screen appears.
3. Move the cursor to “COMMON” and press the
[ENTER] button.
4. In the “KNOB” tab page, move the cursor to one of
the items in Knob 1 Function–Knob 4 Function, and
change the parameter you want to assign.
MEMO
¹ You can also access this screen by operating the [1]–[4] knobs
while holding down the [MENU] button when Knob 1–4 Source is
set to “SYSTEM”.
¹ For details on the functions you can assign, see SYSTEM EDIT >
COMMON > KNOB in the “Parameter Guide” (Roland website).
5. When you’re nished making the settings, press
the [WRITE] button to save the system settings
(p. 32).
Editing assigned parameters in the scene
settings
1. Press the [MENU] button.
The MENU screen appears.
2. Move the cursor to “SCENE EDIT” and press the
[ENTER] button.
The SCENE EDIT screen appears.
3. Move the cursor to “COMMON” and press the
[ENTER] button.
4. In the “KNOB” tab page, move the cursor to one of
the items in Knob 1 Function–Knob 4 Function and
change the parameter you want to assign.
MEMO
¹ You can also access this screen by operating the [1]–[4] knobs
while holding down the [MENU] button when Knob 1–4 Source is
set to “SCENE”.
¹ For details on the functions you can assign, see SCENE EDIT >
COMMON > KNOB in the “Parameter Guide” (Roland website).
5. When you’re nished with the settings, press the
[WRITE] button to save the scene (p. 32).
Editing the setting source of the assigned
parameters
1. Press the [MENU] button.
The MENU screen appears.
2. Move the cursor to “SYSTEM EDIT” and press the
[ENTER] button.
The SYSTEM EDIT screen appears.
3. Move the cursor to “COMMON” and press the
[ENTER] button.
4. On the “KNOB” tab page, move the cursor to one
of the items in Knob 1 Source–Knob 4 Source, and
select “SCENE” or “SYSTEM”.
5. When you’re nished making the settings, press
the [WRITE] button to save the system settings
(p. 32).