Roland LEC-330 - Performing Feed Correction to Alleviate Horizontal Bands and the Like

Chapter 5 Feature Reference
5-5 Optimizing Printing to Match Media Thickness
111
Chapter 5 Feature Reference
Performing Feed Correction to Alleviate Horizontal Bands and the Like
Procedure
1. Print a test pattern.

Press .
Press
several times.

Press .
Press
to start printing.
2. Read the correction values from the test pattern.
In the printing example shown below, "-0.40" becomes the correction value.
3. Enter the correction values that you read.
Press .
Press
.
Use
to make the setting for the cor-
rection value.
Press
to enable the setting.
4. Go back to the original screen.
Press .
Press
to go back to the original screen.
MENU
CALIBRATION
CALIBRATION
TEST PRINT
SETTING
- 0.40%0.00%
W 736mm
SETUP SHEET
ROLL
Choose the one that has the smallest
gap and the least amount of overlap.
Test pattern
Current correction value
Gap present
Overlap