26
Chapter 1 Introduction Chapter 1 Introduction
1-2 Part Names and Functions
Printer Unit
Air-intake port
This is where air intake is performed to lessen the charac-
teristic odor of ECO-UV inks. A deodorizer must be provided
separately.
"Setup guide"
Maintenance cover
You remove this when you
perform cleaning of the
print heads.
Main power switch
Power-cord connector
This supplies power to the
printer.
Status LED
This ashes yellow while data is being re-
ceived from the network.
Link LED
This lights up green when the connection
to the network is correct.
Cartridge slots
There are where ink cartridges
are installed.
Drain bottle
This collects drained ink
and other such uids.
Stopper
Shaft
Brake
This helps to ensure
stable media feed.
Ethernet connector
This is used to connect the printer to a
network.
Rear cover
Be sure to install this when
performing printing.
Media guide
This prevents the end of the
media from striking the stays
or other areas, which can cause
the media to come loose.
Loading lever
You operate this when you
load media.
Operation panel
You use this to perform
various operations.
P. 28, "Operation Panel"
Front cover
Be sure to close this when
you perform printing.
Side cover
You remove this when you
perform maintenance.
Media discharge port
Sti media is discharged
here.
Media discharge port
Media is normally discharged here.
To Next Page
Loading...
