7-2 Printing or Cutting Area
Maximum Area
The printing or cutting area along the horizontal plane (the direction in which the carriage moves) is
determined by the position of the pinch rollers.
*Margin length required by the media take-up and feed systems is approximately 1,100 mm (43 in.).
Maximum Area When Using Crop Marks
When crop marks are used, the printing or cutting area is reduced from the maximum area by an amount
equal to the crop marks.
Printing or cutting area
12.5 mm (0.5 in.)
Crop mark
Maximum area
10 mm (0.4 in.)
10 mm (0.4 in.)
10 mm (0.4 in.)
10 mm (0.4 in.)
12.5 mm (0.5 in.)
12.5 mm (0.5 in.)
12.5 mm (0.5 in.)
Max. 736 mm (29 in.)
Media
Pinch roller (left)
10 mm
(0.4 in.)
Max. 24,998 mm (984 in.)
1.5 mm
(0.1 in.)
75 mm*
(3 in.)
If "EDGE" or "PIECE" is selected in
the [SETUP SHEET] menu.
Origin point for printing or
cutting coordinates (0,0)
I f " E D G E " o r
"PIECE" is select-
ed in the [SETUP
SHEET] menu.
75 mm*
(3 in.)
Pinch roller (right)
10 mm
(0.4 in.)
1.5 mm
(0.1 in.)
Printing or
cutting area
210mm
(8.3 in.)
To Next Page
Loading...
