6-3 The Media Jams
The Media Jams
If an error message is displayed because
the media has jammed, immediately correct
the problem. Failure to do so may damage
the print heads.
P. 161, [MOTOR ERROR TURN POWER OFF]
Is the media warped or wrinkled?
Many factors can cause warping or wrinkling. Refer
to the following and correct the problem.
P. 156, "Media Wrinkles or Shrinks, or Feed Is Unstable"
Is the height of the print heads too low?
Try raising the heads higher. Media may inevitably
warp or wrinkle slightly, so adjust the height of the
heads to take this into account.
P. 106, "Adjusting Head Height to Match Media Thick-
ness"
To Next Page
Loading...
