Aligning Automatically and Cutting
When you make the setting for reading crop marks when sending cutting data from the computer,
alignment is performed with the presence or absence of crop marks determined automatically. For in-
formation on how to make the setting, refer to the documentation for the software RIP you're using.
Procedure
Load the media.
Angled no more than 5 degrees.
Otherwise alignment becomes impossible.
Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the
gure appears and operation stops. If this happens, press
, then
take action as follows.
Reload the media, then send the data again.
Crop marks Blade protection
5 degrees or more
5 degrees or more
To Next Page
Loading...
