Roland LEC-330 - Correcting Misalignment for Printing and Cutting When Using Crop Marks

5-7 Performing Printing and Cutting Separately
126
Chapter 5 Feature Reference
Chapter 5 Feature Reference
2. Set the align points.

Use to align the center of the blade with the loca-
tion shown in the gure.

Hold down for one second or longer.
The number of the align point you set is automatically deter-
mined.

Press .

Repeat steps  through  to specify other align points as required.

Send the cutting data and perform cutting.
About Align Points
The numbers for align points are determined with reference to the location of the base point. You can-
not set an align point unless you specify a base point. Redoing the setting for the base point clears any
align points that have been set.
Correcting Misalignment for Printing and Cutting When Using Crop Marks
Procedure
1. Check the setting for the [AUTO ENV. MATCH] menu item.
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 102, "Executing Environment Matching Automatically"
SETTING
ALIGN POINT 1
This indicates that the base point
and align point 1 have been set.