Performing Distance Correction During Cutting
Procedure
Press .
Press
several times.
Press .
Press
twice.
Press twice.
Use
to make the setting for the cor-
rection value.
Press
to enable the setting for [FEED SET-
TING].
Press .
Press
.
Press .
Use
to make the setting for the cor-
rection value.
Press
to enable the setting for [SCAN SET-
TING].
Press .
Press
to go back to the original screen.
Description
The movement distance for the media changes subtly depending on the media's thickness. This means
that the length of a line when cut may dier from the length setting in the data. You enter a correction
value when you want to align the lengths of cut lines precisely.
When performing printing followed immediately by cutting, be sure to set this to "0.00."
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
To Next Page
Loading...
