Roland LEC-330 - Switching the Power on and off

Chapter 2 Basic Operation
33
Chapter 2 Basic Operation
2-2 Switching the Power On and Off
Switching the Power On and Off
This machine has a main power switch and a sub power switch. Switch on both to use the machine.
Whenever printing is nished, switch o the sub power. You also ip down the loading lever to the
rear of the machine.
Leave the main power switch

on at all times, never switching it o. Leaving it on activates the alarm
feature.
 P. 86, "Alarm Feature"
Important Note on Switching Off the Power
Never switch off the main power or unplug the power cord suddenly while operation is
in progress. Doing so may damage the print heads. Be sure to rst switch off the sub
power.
If the main power is accidentally switched off, immediately turn the power back on.

Sub power
switch

Main power
switch
Turn this switch on after
closing the front cover.
To turn it off, hold down
the switch for one sec-
ond or longer.
Be sure to
leave switched
on at all times.
Back of the printer Front of the printer
Flip the loading lever down
to the rear when not in use.