6-8 If an Error Message Appears
This describes the error messages that may
appear on the machine's display, and how
to take action to remedy the problem. If the
action described here does not correct the
problem, or if an error message not described
here appears, contact your authorized Ro-
land DG Corp. dealer.
[ALIGN POINT POSITION INVALID]
An attempt was made to set an align point
at a location where the setting cannot be
made.
No align point can be set when the angle of the base
point and the align point is too large. Reload the
media correctly, so that the angle is minimized, then
set the base point and the align point again to match
the crop marks.
P. 124, "Aligning Automatically and Cutting"
[CARRIAGES ARE SEPARATED]
The cutting carriage and the printing car-
riage were improperly disconnected.
A problem such as a media jam occurred, impeding
correct operation. Operation cannot be continued.
Switch the sub power o, then back on.
[CAN'T PRINT CROP CONTINUE?]
The size of the data including the crop marks
is larger than the printing or cutting area of
the loaded media.
To continue performing output without correcting
this, press
. At this time, the portion extend-
ing beyond the printing or cutting area and the crop
marks are not printed. To stop printing, stop sending
data from the computer, then raise the loading lever.
Make the printing or cutting area wider, such as by
replacing the media with a larger piece of media or
by changing the positions of the pinch rollers, then
send the data again.
The size of the data being output is too
small.
Make the scanning-direction size of the data at least
65 mm (2-9/16 in). To continue performing output
without correcting this, press . At this time,
the data is output without printing the crop marks.
To stop output, stop sending data from the computer,
then hold down
for one second or longer.
Change the size of the data, then send the data again.
There is no limitation in the size of the data in the
media-feed direction.
[CROPMARK ERROR NOT FOUND]
Automatic detection of crop marks could
not be accomplished.
Load the media at the correct position and perform
detection of crop marks again. If repeating automatic
crop-mark detection results in an error again, then
perform manual crop-mark detection. Depending
on the media, it may not be possible to detect crop
marks automatically.
P. 125, "Aligning Manually and Cutting"
TEMPERATURE IS TOO HIGH **°C]
The temperature of the location where the
machine is installed has risen above the
ambient temperature at which the machine
can operate.
Operation cannot be continued. Switch o the sub
power. The displayed temperature is the current
ambient temperature of the installation location.
Bring the installed location to a temperature at
which operation is possible (20 to 32°C) and allow
the machine to come to room temperature, then
turn on the power.
[SERVICE CALL xxxx]
An unrecoverable error occurred, or part
replacement that must be performed by a
service technician is required.
Note the number displayed, then switch o the sub
power. After you switch o the power, inform your
authorized Roland DG Corp. dealer of the number
that appeared on the display.
To Next Page
Loading...
