Roland LEC-330 - Verifying the Setting for the Amount Remaining Every Time the Media Is Changed

Chapter 5 Feature Reference
5-12 Viewing Information about the Media and the System
137
Chapter 5 Feature Reference
Verifying the Setting for the Amount Remaining Every Time the Media Is Changed
Procedure

Press .
Press
several times.

Press .
Press
twice.

Press .
Use
to select "ENABLE."
Press
to enable the setting.

Press .
Press
to go back to the original screen.
Description
Setting this to "ENABLE" automatically displays [SHEET REMAIN] whenever you change the media and
nish setup. This makes it impossible to go on to the next operation unless you redo the setting for
the amount remaining. This can be useful for keeping you from forgetting to redo the setting when
you change the media. When you set this to "ENABLE," however, be sure also to set the [EDGE DETEC-
TION] menu item to "ENABLE." When [EDGE DETECTION] is set to "DISABLE," then [SHEET REMAIN] is
not displayed automatically, regardless of the setting for [AUTO DISPLAY].

P. 93, "Using Transparent Media"
Also, when sheet media is loaded (that is, when [SETUP SHEET] is set to "PIECE"), the setting for the
amount of remaining media is made automatically, and so this menu is not displayed.
Default Setting
[AUTO DISPLAY]: DISABLE
MENU
SHEET REMAIN
SHHET REMAIN
AUTO DISPLAY
AUTO DISPLAY
DISABLE
ENABLE
W 736mm
SETUP SHEET
ROLL