Roland LEC-330 - Correcting Misalignment of the Printing and Cutting Positions

5-6 Making Various Adjustments for Cutting
120
Chapter 5 Feature Reference
Chapter 5 Feature Reference
Correcting Misalignment of the Printing and Cutting Positions
Procedure
1. Check the setting for the [AUTO ENV. MATCH] menu item.
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 102, "Executing Environment Matching Automatically"
2. Execute the [ADJUST BI-DIR] menu item.

Load the media.
 P. 35, "Loading Media," p. 98, "How to Load Sheet Media"

Perform bidirectional adjustment.
 P. 107, "Correcting for Misalignment in Bidirectional Printing," p. 108, "Correcting for Misalignment in Bidi-
rectional Printing More Precisely"
3. Print a test pattern and cut it.

Press .
Press
several times.

Press .

Press .
Press
.
The test pattern is printed at three locations: at the two edges
and in the center.
When adjustment is needed, go on to the steps below.
MENU
CUTTING MENU
CUTTING MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT
Printing
position
Cutting
position
Cutting position and printing
position are misaligned.
Cutting position and print-
ing position are aligned.
Printing
position
Cutting
position