5-6 Making Various Adjustments for Cutting
122
Chapter 5 Feature Reference
7.
Check the results of adjustment.
Press .
Press
to execute.
If the printing and cutting lines are aligned, adjustment is
complete.
If further adjustment is needed, go back to step
6.
and ne-
tune the adjustment.
Description
You perform this when printing followed immediately by cutting yields positioning for printing and
cutting that is slightly misaligned. You print alignment marks, perform detection of the printed marks,
and correct the discrepancy.
Subtle misalignment between the printing and cutting positions may occur due to the thickness of the
media or the head height. We recommend making correction to match the media you're using.
Default Setting
[F] (feed direction): 0.00 mm
[S] (scanning direction): 0.00 mm
To Next Page
Loading...
