Roland LEC-330 - Page 163

Chapter 6 What to Do If Chapter 6 What to Do If
6-8 If an Error Message Appears
161
Chapter 6 What to Do If
[WRONG CARTRIDGE]
A ink cartridge that cannot be used was
installed.
Remove the ink cartridge to clear the error. Use a
cartridge of the specied type.
[AVOIDING DRY-UP TURN OFF POWER]
The print heads were forced to standby po-
sition to prevent them from drying out.
Operation cannot be continued. Switch the sub
power o, then back on. Opening the front cover
while printing is in progress causes an emergency
stop. Never allow the print heads to remain in this
state.
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch o the sub
power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is
allowed to stand with the error uncorrected, the print
heads may dry out and become damaged.
This error may be caused by such factors as a mistake
in loading the media, a media jam, or an operation
that pulls the media with excessive force.
The media has jammed.
Carefully remove the jammed media. The print heads
may also be damaged. Perform head cleaning, then
perform a printing test and check the results.
The media was pulled with excessive
force.
Excessive tension was applied to the media, and
additional action is necessary to recover from this
state. First, move the loading lever to the rear and
adjust the media to create a small amount of slack,
then switch on the sub power.
[CANCELED FOR MOTOR PROTECTION]
Continuous operation made the pump
motor become hot, and so operation was
paused.
Press any key to clear the error. Allow the machine to
stand for approximately 40 minutes before resuming
operation.
[LONG MEDIA CLAMP IS INSTALLED]
Media cutoff was attempted even though
[MEDIA CLAMP] is set to “LONG.”
To prevent malfunction or damage to the machine,
media-cuto operations are not performed when
[MEDIA CLAMP] is set to “LONG.” Use
to go
back to the original screen, then either detach the
media clamps, or replace them with short media
clamps and set [MEDIA CLAMP] to “SHORT.”
 P. 42, "Cutting O the Media"
[CANCELED FOR MOTOR PROTECTION]
An unusable print head is installed.
Switch o the sub power. After you switch o the
power, inform your authorized Roland DG Corp.
dealer.