Chapter 3 Operation of the Media Take-up System
3-2 Using the Media Take-up System
59
Chapter 3 Operation of the Media Take-up System
Press to adjust the length of the media to be pulled out.
You can adjust the length of the media in 10-millimeter steps by pressing .
To pull out media continuously, hold down
.
Fasten the media in place with tape at three locations (the center and both
edges) so that the media is not at an angle.
■Take-up with outward curl
■Take-up with inward curl
Fasten rst.
Paper tube
Adhesive tape (3 places)
Fasten rst.
Paper tube
Adhesive tape (3 places)
To Next Page
Loading...
